They have labeled wires.” Yes, they do have labeled wires. One of the best descriptions for this location is “Sensors are behind the plastic under clutch pedal. That is putting their comments mildly as they do not like the positioning of these sensors. SPN 1067 Brake Signal Sensor 1 LocationĪccording to some owners, the location for this sensor is not in a very convenient spot. Just make sure you understand the blink code so that you get to the right code definition.

From what we can tell it is not a performance-inhibiting fault code but one that should not be overlooked or ignored. This fault code may appear when you replace your ECU. Perform a full application of the service brake and hold for 5 seconds. Apply ignition power, and wait 30 seconds. “ To perform a calibration procedure of the Brake Demand Sensor(s), ensure that the air system is fully charged. To do this procedure you need to follow these instructions: This procedure is found on page 43 of the Bendix troubleshooting manual.

What that blink code is telling you is that you need to perform a static sensor calibration procedure. The blink code for Bendix for this specific fault code will be 24-6. The problem you are facing will have something to do with the brake sensors that enable your ABS system to work properly.

One explanation would be- Plausibility error brake demand sensor but if you have the Bendix brand of ABS system in your vehicle, then you are looking at PS Not Calibrated and it comes under the heading rake Demand/Load Sensor DTCs.

How to calibrate bendix abs